|
| |
This is a very functional volt meter but I was hoping to use it to switch between my battery voltage to supply voltage with a spdt switch but it only reads 3.0 to 4.9 volt "per cell" and is intended for use with lipo packs in the RC hobby world |
| |
Reviewed by: Tim Murphy from South Al.
on 4/10/2012 |
|
 |
| |
Nice little battery display that I used on a dud 510 cartomizer body and wired up the battery connections to. I added some shrink wrap tubing to make my own voltage display that I can screw onto various mods to show what the voltage is currently set at. It's my quick got to variable voltage display I can use on my mods. Very nice, consistent, and works great. |
| |
Reviewed by: Ron Whitney from Nebraska.
on 1/14/2012 |
|
|
| |
Love this led readout it works everytime you need it to. Just wish they weren't so expensive. |
| |
Reviewed by: steven mackenzie from USA.
on 5/8/2011 |
|
|
| |
I ordered the unit shown here $7 but I received the $15 assembled version with 510 connectors. I appreciate the upgrade but it limited the uses for the indicator. I didn't want to disassemble it so I used one of the 510 battery contacts I bought and put leads on it to make a loose wired tester of it. Works great. |
| |
Reviewed by: CB from PA.
on 4/8/2011 |
|
|
| |
This unit is great for making a little mod to check voltage on the fly. Applying voltage for the full 2 seconds needed to get a good reading under load can cause some liquid burning at high voltages.
The accuracy is off by about 0.2 volts on the one I got compared to my Voltmeter but I am not gonna complain at this price.
The ground pin is as indicated above. The other pins are for 6 different positive connections that share the same ground.
Great price! |
| |
Reviewed by: Alex Spear from Sacramento, CA.
on 3/31/2011 |
|
|
| |
These are originally for r/c hobbyists to test multi-cell LiPo batteries out at the field. This is one of the best prices I have seen on one of these units and it is a nice one to boot. They work great as indicated for building into mods as well. |
| |
Reviewed by: Bryan Griffin from SoCal.
on 3/14/2011 |
|
|
| |
Purchased this and a 510 battery extension (male connector on one end, female on other) and wired it up with some heavy gauge wire (for stiffness) and made myself a battery voltage indicator for my 510 mods. No need to use a multimeter anymore! |
| |
Reviewed by: Chris Constant from Louisville, KY.
on 2/21/2011 |
|
|
| |
Works well. Seems to have a 2 second update cycle.Have not measured current draw yet but it causes charger LED to flicker. Nice addition. |
| |
Reviewed by: Bob from Memphis.
on 2/11/2011 |
|
|
Shopping Cart - 0 item(s)/Total: $0.00
