6mm x 6mm Tactile Switch with 4mm Actuator

6mm x 6mm Tactile Switch with 4mm Actuator

Great switch for box mods or flashlight mods. I like these best for box mods. Nice low profile but enough sticking out for a good click. Nice long leads for easier soldering.

Rated 12v, 50mA
Color: Black

Customer Reviews

See All Reviews

	Flawless operation
	I picked up several of these for my mod projects, at 3.7v, no problems at all after months of use
	Reviewed by: Michael Green from Iowa. on 1/3/2012

	Good and cheap
	Good for 3.7 stuff not so hot for the 5v stuff
	Reviewed by: dusty vandale from WV. on 6/2/2011

	Recommended
	These work awesome in a 3.7V AA box mod. Can put it almost anywhere! No problems!
	Reviewed by: Ben Derrington from Missouri. on 5/14/2011

	Tactile Switch
	Great little switch! Tall enough to stick out of the side on battery box, good click, small size, works great for PCB mounting (when mounted on the PCB no glue/epoxy is needed so no stuck switches!)
	Reviewed by: Dan from Colorado. on 9/11/2010

	I don't recommend these
	I have used two of these. Both were wired directly to the hot wire on a 3.7 volt device (no mosfet/regulator). The first one worked great for about a week and then started acting funny. After another week It only worked about 15% of the time. Gave up on that one and wired in the new one. It worked for about ten seconds and then quit at which point it no longer clicked when you pressed it. I do NOT recommend these and would suggest looking at some of the other switches offered here.
	Reviewed by: Tyler from APO, AP. on 8/10/2010

	Tactile Switch
	I picked up a few of these to try out and they work great. They have a low profile so it's not jutting out to get snagged on your pocket and a nice click when you push. My only qualm with them is they do make your finger a little sore if you are a heavy vaper. Other than that, they are nice to work with.
	Reviewed by: Scott from endicott, ny. on 7/25/2010