|
| |
The battery seems to work great when it has a charge. But it doesn't seem to hole a charge very long. If you vape heavy, expect to have to charge before an hour of vaping. Good back up though. Works good and produces a good vapor. Only 3 stars because of how much of a charge it holds. Otherwise I'd rate 5 stars. |
| |
Reviewed by: Chad Harmon from St. Louis.
on 12/27/2011 |
|
 |
| |
this will fit small pcc like volcano magma pcc but i shaved the button a bit with a new razor about a 8th of an inch and it works well in the pcc. |
| |
Reviewed by: joe canale from pa.
on 9/30/2011 |
|
|
| |
I purchased this so I would have a third battery. So far its done its job. I do notice it doesn't carry a charge as long as the batteries that came with my 510 kit but again...this is only a backup battery for me. I will buy more in future. |
| |
Reviewed by: Claudia Rogers from Georgia.
on 2/18/2011 |
|
|
| |
Great price and speedy shipping on order. Thank you for the extra rubber buttons. They work great! |
| |
Reviewed by: Terry L Graham from GRAND BLANC.
on 12/30/2010 |
|
|
| |
These batteries are good, as far as 510 batteries go. For the people saying it works intermittently, that's called a cutoff. Most 'basic' batteries have them. It's to keep you from burning the battery up by using it too much in a short period of time, and also to avoid it going off in your pocket and burning a hole or melting the battery. If you don't like cutoffs, and you hit them often, you need to step up to a bigger battery that will accomodate your vaping. |
| |
Reviewed by: Noitall from Illinois.
on 10/15/2010 |
|
|
| |
We had purchased a pair of these to have as backup batteries. Obviously, we have to charge these more often than the megas and especially our lovely Hello 016's. But, I must say these are tiny and work Very Well. |
| |
Reviewed by: Kirk Morger from Texas.
on 9/13/2010 |
|
|
| |
I had bought SLB batteries in the past that worked great, these ones do the job but sometimes the button/switch has issues turning on/off when pushing at an angle. Never had that issue with my 2 previous slb batts. Could have been the batch or maybe they fixed the issue by now. |
| |
Reviewed by: Gregg Muller from Spokane, WA.
on 8/13/2010 |
|
|
| |
I have had issues w/ these batts working consistently. They will work well right after a fresh charge, but then they will quit and start blinking after 3 or 4 pulls(literally). Then they will start to work again if I wait a few minutes for another pull or two. Then rinse and repeat.
Great service, but unless I caught a bad batch 2 different times, I'd have to say these batts are a little unreliable w/ their performance. |
| |
Reviewed by: Chris from NY.
on 8/13/2010 |
|
|
Shopping Cart - 0 item(s)/Total: $0.00
