|
| |
I've used two of these for variable box mods and they work great. Just be careful when drilling the plastic, because if you use to much force while drilling holes in them you can crack them - however that was my fault entirely. They make great little stealthy in the hand box mods with 14500 batteries. Plus there is enough room to add variable voltage components. Just use enough hot glue or exposy when sealing the vv components up and you'll have a nice little pv box mod. |
| |
Reviewed by: Ron Whitney from Nebraska.
on 1/14/2012 |
|
 |
| |
these things are great for mods of vv and 5 volt. with the on and off switch is nice cause you can't push the button and burn things out. |
| |
Reviewed by: james mineau from north port florida.
on 12/5/2011 |
|
 |
| |
Perfect for 5V mods! |
| |
Reviewed by: Jamison Ashby from Wisconsin.
on 9/12/2011 |
|
 |
| |
Wired it so it could use two batteries in parallel plus it doubles the mah. Last for a couple days this way. Perfect size in my little girly hands. |
| |
Reviewed by: Jerry Densmore from Jerry Frankfort,IN..
on 8/31/2011 |
|
 |
| |
Ordered this and all the connectors are solid, the wires are long enough to use for the box mod, and the master switch handles current well. Would definitely buy this over and over again. |
| |
Reviewed by: Dalton Cunningham from Missouri.
on 8/2/2011 |
|
 |
| |
Good box, good size, used with 14500 batts, good results. |
| |
Reviewed by: Tek from Rhode Island.
on 7/19/2011 |
|
 |
| |
What can you say, it's a three slot AA battery holder. Same as you might get from radio shack but it comes to your door with other good things MadVapes sells.
Used small drill size to drill pilot holes for the battery connector, switch, LED, variable resistor knob, then used a step drill to fine tune the fitting. If using only drill bits make sure they are sharp and don't try and increase size too rapidly.
Makes it easy to create a custom inexpensive PV box. |
| |
Reviewed by: John Keene from Kentucky.
on 5/18/2011 |
|
 |
| |
Great for a 3.7v Box mod with extra slot(s) for storage, or a bottom feeder.
EVEN BETTER for a 5v box mod using dual 14500's. High quality and dirt cheap price! Will buy again! |
| |
Reviewed by: Ben Derrington from Missouri.
on 5/14/2011 |
|
 |